How to use MagicResin's 4" Deep Pour & Casting Resin
Want to learn how to use our Table Top & Coating resin instead? Click here.
For optimal results, make sure that the temperature of the room and the resin is between 24-27c (75-80f).
Tip: If for any reason your bottles are cold, you can put them in warm water to accelerate the process.
A single pour should be no more than 4” of resin, else you will need to do multiple pours.
To purchase table top resin, check out our Table Top & Coating Resin.
STEP 1: MEASURE
Into a mixing cup, pour twice the amount of resin (A) for each measurement of hardener (B) (2:1 ratio). Ex.: 500ml of resin (A) with 250ml of hardener (B). If you want to measure by weight, the ratio is 100A:45B. Ex: 300g of resin (A) with 135g of hardener (B).
STEP 2: MIX
Stir both parts together for 4-5 minutes. Make sure to scrap the sides while stirring. Once done, you have around 1 hour of working time.
STEP 3: POUR
Make sure that your project is leveled and pour the resin on it.
Tip: 15 minutes after pouring, you can quickly pass a blow torch a few inches over the resin to pop air bubbles.
STEP 4: WAIT
Your project will be tack-free after 3-4 days, and will be fully cured after 7 days. This curing time helps to release as many air bubbles as possible, and allows for deeper pours.
The remaining step is to enjoy your amazing creation!